Log of Alberg 30 #262 on 16 January 2017


Date: 16 January 2017 12:50 till 16 January 2017 14:20
Endpoints: Smith's Marina to Smith's Marina
Purpose: V-berth
Complement: Yoni Bresler
Weather: 40's

  • Squared off the inboard forward and outboard forward corners of the hole cut into the port side of the v-berth using my father's sabre saw.
  • Trimmed a panel of 1/2" plywood to match the hole cut into the port side of the v-berth using my father's circular saw.
  • Removed the alternator from the engine to give to Pasco for evaluation.
  • Note:
    • The single heavier gauge wire with a ring terminal connects to the insulated terminal labeled "BAT"
    • The combination of heavier gauge wire and lighter gauge wire on the same ring terminal connect to the unlabeled insulated terminal further from the terminal labeled "BAT"
    • Nuts and washers for the connections remain attached to the alternator.
    • Saddle pivot bolt reinserted in saddle.
    • Position locking bolt placed in Snapware container holding flashlights.

© Jonathan M. Bresler