- Forgot the epoxy resin and hardener. No epoxy work today.
-
- Vacuumed a quantity of sand and a bit of water out of the bilge.
-
- Painted the second coat on the knees and bulkhead where the forward lower and upper shround chainplates and backing plates will be located.
-
- Chamfered the holes in the cabin top left when the Danforth anchor chocks and U-bolt were removed.
- Removed the wooden odds and ends holder secured to the port side of the bulkhead next to the companionway to make room for the one loop handles to be installed there.
- Chamfered the holes in the bulkhead left when the wooden odds and ends holder was removed.
- Found a fuse holder (lower black connector in photo) with 6A 250V glass cylinder fuse for the VHF radio inside the split loom covering the radio power and antenna wiring. Upper black connector in photo is a power disconnect for the VHF radio. Wire nuts were used by a previous owner to connect power to the VHF radio.
- Replaced split loom for now.
