- Removed finish from the chimney teak trim ring using the Heat Gun
- Sanded chimney teak trim with 150 grit and 220 grit using the Ridgid quarter sheet sander
-
- Removed teak cleat on front bulkhead of v-berth that holds the table.
- Masked off various items in the v-berth (about one hour).
- Removed eight nut holding the forward hatch. Two of the bronze screws broke (about one half-hour).
- Removed the wood screws holding the cleats for the two access panels in the v-berth, one port side, one starboard.
- Applied first coat of High Gloss White
to
- the hull to deck joint,
- the forward bulkhead,
- the aft bulkhead,
- the hull above the shelf,
- the top side of the shelf,
- the under side of the self,
- the vertical face of the forward hatch opening,
- the area around the deck organizer located on the port side at the forward end of the coach roof,
- the perimeter of the port side of the v-berth flat, and
- a strip about two inches wide around each of the items above so that the rest can be rolled rather than brushed.