- Removed tape masking off the areas painted with Brightside
.
- Added torlin 5/16" diameter balls to replace those that I lost from the traveller car during removal.
- Installed traveller with Bed-It Butyl Tape
.
- Re-rove traveller control line.
- Installed mainsheet.
- Installed metal cover over the centerline hole in the aft wall of the cockpit.
- Installed staples for the hasps for the seat locker covers.
- Attached a twist-on BNC connector on the GPS antenna's RG-58A/U coax. Not very happy with the fit.
- Tested the GPSMAP 192C
. Works. GPS coordinates reported match those on my iPhone.
- Installed the Garmin GPSMAP 192C.
-
- Next steps:
- Need to get back to work on the cockpit locker seat lids and companionway trim. First item is to sand, then prime for Awlwood
.
- Need to Cetol the coamings, companionway hatch, and companionway boards.