- Third and last coat of Cetol Marine Natural Light
on inboard side of coamings and underside of icebox lid.
-
- Cleaned up the mounting holes in the companion way trim using a 3/8" forstner bit. Afterwards, the 3/8" bungs fit well.
- Installed companionway trim, not too tight, the screws dead end in the fiberglass.
- Installed bungs into the compantionway trim using a dab of wood glue.
- Installed cockpit locker seats.
- Rove main and jib halyards.
- Sanded and applied third coat of Brightside
to companionway rim.
- Applied second coat of Brightside to ruddershaft blister.
-
- Next steps:
- Trim bungs.
- Install coamings, winchbases, and winches.
- Attach cleats and various fittings to coamings.
- Install companionway hatch and hatch boards.
- Bend on sails.
- Apply Awlwood yellow primer to the surface of the companionway trim with the bungs.
Note: The photos of the cockpit locker seats were taken on 2018-08-07
