- Sanded fiberglass on underside of keel forefoot that was added yesterday.
- Removed the existing three blade prop and installed the 13" x 8" removed from Interrupt. Work done by Abel and Diego of Smith's Marina.
- Installed new shaft anode a CM C02 from Martyr Anodes
.
- Prepared engine for the season: installed impeller, installed raw water strainer, installed and tensioned fan belts, checked oil levels, no oil required.
- Washed boot stripe and taped in preparation for repainting.
- Attempted to repaint boot stripe. New paint is bad, does not spread properly. Wiped off the two foot of boot stripe that I attempted to cover. Redo with previous choice %zinc.
- Applied the second coat of Awlwood to the companionway sill after sanding with 220 grit.
- Applied a first coat of Awlwood to the top, front, fore and aft sides of the cockpit seat lockers after sanding with 400 grit.