- Used a 1/8" x 1" cotter pin to secure the castellated nut on the prop installed yesterday.
- When the prop is hidden behind the deadwood, the keyway for the prop and for the engine coupling is TDC and BDC.
- Applied the third coat of Awlwood to the companionway sill after sanding with 220 grit.
- Applied a second coat of Awlwood to the top, front, fore and aft sides of the cockpit seat lockers after sanding with 400 grit.
- Taped the bottom of the boot stripe.
- Applied to two coats of Rustoleum High Gloss White
to the boot stripe.
- Painted with EZ Poxy 2
filled area were manual bilge pump outlet was located.
- Painted the hull with PCA Gold
. One coat, about 1/2 a gallon. Left a one inch strip immediately below the boot stripe unpainted as the boot stripe was still wet.