- Removed bow light, anchor light, and steaming light wiring from panel through port cockpit locker along the port side of the board to the head.
- Stern light and blower wiring remain in place unchanged.
- Ran new wiring for deck light (16AWG), anchor light (16AWG) and ground (10AWG) from panel behind the aftmost trim strip of the icebox along the port side of the boat to the head.
- Installed Blue Sea Common 100A Mini Grounding BusBar -- 6 Gang
for ground wire from the mast.
- Remaining amount of new wire on spools too short to run from panel to head. So reused the previous 14AWG/2 cable for navigation (bow and windex) and streaming lights.
- Wrapped wires from mast to v-berth bulkhead with spiral wrap.
- Wrapped wires from panel to icebox with spiral wrap.
- The terminal block has circuits for:
- Anchor light (12v power)
- Windex light (12v power)
- Bi-color bow navigation light (12v power)
- Steaming light (12v power)
- Deck light (12v power)
- Four circuits for the wind instrument and its ground.
- Tested wind instrument. Works as expected.
- Tested depth sounder. Works as expected.
- Tested steaming light. Works as expected.
- Tested stern light. Works as expected.
- Tested bow light. Works as expected.
- Tested VHF radio power circuit. Works as expected.
-
- Filled unused deck penetrations at mast and one in v-berth for holding the table top with epoxy resin.
- Lubricated Groco valves for sink discharge and engine cooling water discharge with Ulube Grease
using Slippery Pete Mini Grease Gun
-
- Need to grease valves in head and valve for high discharge bilge pump.
- Need to connect compass lights to navigation light circuit.
- Need to document the current electrical wiring configuration.