- Purchased a Precision DC31-HD group size 31
maintanence free battery from Pasco Battery Warehouse
.
- Installed the new DC31-HD battery as the start battery (#1).
- Run a length of 6mm luff tape up and down both grooves in the Selden 200 S
to clear/clean the grooves before hoisting the sail. Ran easily.
- Bent on new 135LP genoa from Bacons
.
- Attached new Yale Cordage
3/8" ULS
jibsheet purchased from Annapolis Performance Sailing.
- Reset Garhauer
genoa 40-40 US track car single block
to tenth hole back from forward end of track, fourth hole back from stanchion.
- Bent on Interrupt mainsail.
- Rigged outhaul.
- Rigged first reefing line.
- Test hoisted main.
- Installed fuel fill pad with butyl tape.
- Hung engine ignition key with float on engine raw water intake valve.
-
- Too little wind to sail after yesterday's low pressure system passed through.
